# validated: 2015-12-23 DS fa903dd athena/java/edu/wpi/first/wpilibj/Spark.java
#----------------------------------------------------------------------------
# Copyright (c) FIRST 2008-2012. All Rights Reserved.
# Open Source Software - may be modified and shared by FRC teams. The code
# must be accompanied by the FIRST BSD license file in the root directory of
# the project.
#----------------------------------------------------------------------------
import hal
from .livewindow import LiveWindow
from .safepwm import SafePWM
__all__ = ["Spark"]
[docs]class Spark(SafePWM):
"""
REV Robotics SPARK Speed Controller
.. not_implemented: initSpark
"""
def __init__(self, channel):
"""Constructor.
:param channel: The PWM channel that the SPARK is attached to. 0-9 are on-board, 10-19 are on the MXP port
.. note ::
Note that the SD540 uses the following bounds for PWM values. These
values should work reasonably well for most controllers, but if users
experience issues such as asymmetric behavior around the deadband or
inability to saturate the controller in either direction, calibration is
recommended. The calibration procedure can be found in the SD540 User
Manual available from Mindsensors.
- 2.003ms = full "forward"
- 1.55ms = the "high end" of the deadband range
- 1.50ms = center of the deadband range (off)
- 1.46ms = the "low end" of the deadband range
- .999ms = full "reverse"
"""
super().__init__(channel)
self.setBounds(2.003, 1.55, 1.50, 1.46, .999)
self.setPeriodMultiplier(self.PeriodMultiplier.k1X)
self.setRaw(self.centerPwm)
self.setZeroLatch()
self.isInverted = False
hal.HALReport(hal.HALUsageReporting.kResourceType_RevSPARK,
self.getChannel())
LiveWindow.addActuatorChannel("Spark", self.getChannel(), self)
[docs] def free(self):
LiveWindow.removeComponent(self)
super().free()
[docs] def set(self, speed, syncGroup=0):
"""Set the PWM value.
The PWM value is set using a range of -1.0 to 1.0, appropriately
scaling the value for the FPGA.
:param speed: The speed to set. Value should be between -1.0 and 1.0.
:type speed: float
:param syncGroup: The update group to add this set() to, pending
updateSyncGroup(). If 0, update immediately.
"""
self.setSpeed(-speed if self.isInverted else speed)
self.feed()
[docs] def setInverted(self, isInverted):
"""
Common interface for inverting the direction of a speed controller.
:param isInverted: The state of inversion (True is inverted).
"""
self.isInverted = isInverted
[docs] def getInverted(self):
"""
Common interface for inverting the direction of a speed controller.
:returns: The state of inversion (True is inverted)
"""
return self.isInverted
[docs] def get(self):
"""Get the recently set value of the PWM.
:returns: The most recently set value for the PWM between -1.0 and 1.0.
:rtype: float
"""
return self.getSpeed()
[docs] def pidWrite(self, output):
"""Write out the PID value as seen in the PIDOutput base object.
:param output: Write out the PWM value as was found in the
:class:`PIDController`.
:type output: float
"""
self.set(output)